Insert Bearings Spherical OD
Ball Bearing Inserts. Constructed of high quality 52100 steel, ball bearing inserts are used inside pillow block and flange housings or in custom housed applications. They are most commonly produced with a spherical OD to allow for misalignment, but are also available with a cylindrical OD.
The SER insert has a cylindrical OD and is equipped with a snap ring in the outside diameter. The SER insert bearing is used in applications where the housing is machined to accept snap rings or the snap ring is used for the retention of the bearing. It features a Neoprene Contact Seal designed to keep lubricant in while keeping contaminants out.UC200 Insert ball bearing with wide inner ring and two set screws. Spherical OD and grease feeding groove. UC Series Insert Bearings has a set screw locking and is held in position on the shaft by two set screws which are directly on the extended end of the inner ring. UC200 Series Insert Ball Bearings are self-aligning for standard load capacity.
- 50,8 mm x 90 mm x 51,59 mm TIMKEN GY1115KRRB3 Insert Bearings Spherical OD
- 3.4375 in
- 3.7500 in
- 41,275 mm x 85 mm x 49,22 mm TIMKEN GY1110KRRB SGT Insert Bearings Spherical OD
- 4.0000 in
- Non-Expansion Bearing (Fixed)
- 55 mm x 100 mm x 46,6 mm TIMKEN GYAE55RRB Insert Bearings Spherical OD
- 0.6250 in
- 3-57/64 in
- 55,5625 mm x 100 mm x 46,6 mm TIMKEN GYA203RRB Insert Bearings Spherical OD
- 50 mm
- Dry 1.65, Periodic Lubrication 3.25 N/mm2 x m/s
- 57,15 mm x 110 mm x 65,07 mm TIMKEN GY1204KRRB Insert Bearings Spherical OD
- 1.3750 in
- 4-59/64 in
- 12,7 mm x 40 mm x 23,8 mm TIMKEN GYA008RRB Insert Bearings Spherical OD
- 2.4375 in
- 2.7000 in